An investigation into dry and wet textile friction and lubrication in practical applications.




Journal Title

Journal ISSN



Volume Title


De Montfort University


Thesis or dissertation

Peer reviewed


The lubrication of dry viscose fibres by a two component finish, and the lubrication of wet Iyocell fabric against metal, with various aqueous lubricant systems, has been studied. Secondary ion mass spectrometry (SIMS) was investigated as a means of providing direct chemical information from finished fibre surfaces. The composition and distribution of a two component finish applied to viscose fibres was determined successfully. When applying finish from a bath, the surface composition of the finished fibres was not controlled by the bath conditions. Increasing the concentration of finish in the bath did, however, increase the total amount of finish deposited, and increasing the concentration of antistat relative to lubricant in the bath increased the amount of antistat relative to lubricant deposited on the finished fibres. Fibre friction was determined using the capstan method. The friction forces, measured for finished viscose fibres, were correlated with the finish application conditions. Increasing the emulsion concentration in the finish bath reduced fibre/metal friction, but finish component ratio, emulsion concentration, dip time and bath temperature did not affect fibre/fibre friction. Spray applying the finish resulted in unfinished regions on the fibre surfaces and the electrical resistance of fibre bundles was not reduced. Bath application of finish did lower electrical resistance in comparison with unfinished fibre, but none of the bath deposition variables had a significant effect on electrical resistance.





Research Institute